Publicidad
Idiomas disponibles
Idiomas disponibles
••
Connections
HTUNER" terminals
"CDtAUX" terminals
"TAPE 1
n
terminals
Connect a tuner.
Use these terminals to connect a
Connect an audio tape deck.
compact disc player (digital audio disc),
or tape deck (playback only).
Tuner (option)
Compact disc player (option)
OUTPUT
lINEQl1T
ff
(R) (L)
"PNDND
H
terminals
Connect a turntabie.
Turntable (option)
i
(GND)
(GND)
Stereo connection
~"-->-I
l,~
cable (option)
Ground wire (option)
Stereo connectio
"TAPE 2IEXT" terminals
cable (option)
Connect a second tape deck or a graphic
equalizer.
Tape deck
2
(option)
UNE IN
UNI: OUT
Speaker terminals ("SPEAKERS")
• Connection of speaker wires
<D
Strip oft the outer covering, and
CD
= =
twist the center conductor.
15
mm
(19/32")
®
Turn completely to the left.
@ Insert wire and turn completely
(])
to the right.
Pull wire to insure a proper
connection.
Nole:
To prevent damage 10 circuitry,
never short-circuit plus (+) and
minus (-) speaker terminals.
'---------------------------------------~
• Remote speaker terminals ("REMOTE")
For connection 10 a second pair of speakers.
Stereo connection
Speaker
connection
cord (option)
(-)(+)
(-)(+)
~~
(right)
Oeft)
Main speaker systems (option)
Tape deck 1 (option)
LlNE IN
UNE OUT
-
Household
AC outlet
The configuration of
the AC outlet and AC
-
power supply cord
differs according to
area.
Speaker impedance selector
Set to the position corresponding to the impedance of the
speaker systems being used.
If a speaker system with an impedance value outside these
ranges is connected, low output, protection circuit aclivation or
amplifier damage may occur.
• 11 either the main or the remote speaker
systems are used:
4~611
(........ ):
For speaker impedance of
4~611.
8~1611(
........):
For speaker impedance of
a~
1611.
• 11 both main and remote speaker systems are
used:
1) If the impedance of both systems is 16 ohms, set the speaker
impedance selector to "16n".
2) If the impedance of both systems is
a
ohms, or one is
a
ohms
and the other is 16 ohms, set the speaker impedance seleclor
to "a11" .
Note:
Be sure 10 make this setting before swilching Ihe power "on".
-4
Publicidad
