Publicidad
Idiomas disponibles
Idiomas disponibles
7.5. GUIDE TO CONFIGURE THE INVERTER
USING THE DISPLAY.
The parameters that must be configured for start-up are as follows:
BLUETOOTH/WIFI COMMUNICATION
•
Bluetooth is used for communication by default, so you
ˆ
must change to WiFi if you want to obtain data from the
hybrid inverter via the EQX-sun app. To do so, go to the
"General Settings" menu and then the "Module Work-
Mode" parameter.
WORK MODE
•
You must enter the work mode that you want. To do so,
ˆ
go to the "General Settings" menu and then the "Work-
Mode Set" parameter.
BATTERY TYPE
•
You must enter the type of battery you want to use.
ˆ
To do so, go to the "General Settings" menu and then
the "Battery_ID Set" parameter. There are two types of
compatible battery manufacturers:
EQX_BATT: Salicru
–
Pylon_HV: PylonTech
–
CT
•
The CT ratio is 80:1 by default and it has to be changed to
ˆ
90:1. To do so, go to the "General Settings" menu and then
the "CT Ratio" parameter.
DOD
•
The DOD limits battery discharge to a minimum SOC (State
ˆ
of Charge) to protect the battery. A DOD value of 90%
indicates a minimum SOC of 10%. To configure it, go to the
"Advanced Settings" menu, using the "1111" password,
and then configure the "On-Grid DOD" and "Off-Grid DOD"
parameters and enable the "OnGrid SocProt." and "OffGrid
SocProt." parameters.
88
Optional
ZERO INJECTION
•
For zero injection to the grid, you must enable the "Export
ˆ
Limit" parameter and set the "Feed in Grid" parameter to
0.0%. These two parameters are in the "General Settings"
menu.
PEAKLOAD SHIFTING
•
To enable the PeakLoad Shifting function, go to the
ˆ
"Advanced Settings" menu, using the password "1111",
enable the "PeakloadShifting" parameter and set the
Pmax power limit with the "SetMaxGrid KVA" parameter.
ECONOMY MODE PROFILE
•
In order to use Economy mode, you must configure a charge
ˆ
and discharge profile. To do so, go to the "Advanced Set-
tings" menu and configure the following parameters for
charging:
"Charge. S. Time": Start time for charging
–
"Charge. E. Time": End time for charging
–
"Charge. P. Lim.": Charging power limit
–
Go to the "Advanced Settings" menu and configure the
ˆ
following parameters for discharging:
"Discharge. S. Time": Start time for discharging
–
"Discharge. E. Time": End time for discharging
–
"Discharge. P. Lim.": Discharging power limit
–
SALICRU
Publicidad
