Publicidad
Idiomas disponibles
Idiomas disponibles
Checking Left 45 °
Bevel Stop
1. Lower head assembly and engage head assembly
lock pin.
2. Slide head assembly completely to the back and
tighten the rail lock knob.
3. Rotate table to the 0 ° miter position.
4. Pull up bevel lock lever to unlock bevel.
5. Move bevel range selector knob to 45o-0° position.
(See page 28)
6. Tilt the saw assembly to the left, then rotate saw
assembly to the right until you feel the stop in the
45 ° left position. This is where the saw is current-
ly set for the 45° left bevel cut.
7. Use the head (remove
ruler) of a combination
square to check blade at the 45 ° stop. Place the
combination square head on the table and press
it's 45 ° surface against the blade. If the blade does
not contact the full length of the square, (figure 1),
follow the calibrating procedure.
Calibrating Left 45 °
Bevel Stop
1. Remove rear cover to expose bolts.
2. Lift bevel lock lever to release bevel lock.
3. Tilt saw to 45 ° left bevel position.
4. Remove the ruler from the combination
square
and position
with 45 ° surface
against
blade.
(Figure 1)
5. Place 10mm open-end wrench on bolt head "F".
While rotating bolt "F", watch blade tilt movement
until it is aligned with the 45 ° surface on combina-
tion square. (Figure 2)
6. Adjust bevel pointer to 45 ° line on bevel scale.
Blade
Combination
Square
Table
Bevel Lock
Lever
Figure 1. Left 45 ° Bevel Stop
Figure 2. Left 45 ° Bevel Adjustment
Adjusting Bevel Lock
Lever Tension
1.Lift bevel lock lever to release bevel lock.
2.Place 17mm open-end flat wrench on bolt head "E"
(Figure 2).
3.Turn nut "E" clockwise 1/8 turn to tighten bevel lock
tension or turn counter-clockwise
to 1/8 turn to
loosen bevel lock tension.
4.Push down bevel lock lever until you feel the lever
snap into the locked position.
5.Verify that bevel lock tension holds the bevel posi-
tion secure and also allows bevel lock lever to lock
down to the point that a solid stop is felt.
6. If necessary, repeat steps 1-5 to adjust the tension.
15.
Publicidad
