Makita RBC414U Instrucciones De Manejo Originales página 15

PUTTING INTO OPERATION
Observe the applicable accident prevention regulations!
Starting
Move at least 3m (10ft) away from the place of refuelling. Place the brushcutter on a clean piece of ground taking care that the cutting tool does
not come into contact with the ground or any other objects.
Cold start
– Grasp the handle (hand pressure activates the safety lock-off lever (1)).
– Press the throttle lever (2) and hold it down.
– Push the I-O switch (3) to START.
– First place the machine on the ground.
– Give a gentle push on the primer pump (4) repeatedly (7-10 times) until fuel
comes into the primer pump.
– Move the choke lever (5) to the top position (
– Firmly hold the unit by your left hand, as illustrated.
– Slowly pull the starter grip until resistance is felt and continue with a smart pull.
– Do not pull out the starter rope to its full extent and do not allow the starter handle
to be retracted without control, but ensure that it is retracted slowly.
– Repeat the starting operation until initial ignitions are heard.
– Depress the choke lever (
starts.
– As soon as the engine starts, immediately tap and release the throttle, thus
releasing the half-throttle lock so that the engine can run in idle.
– Run the engine for approximately one minute at a moderate speed before
applying full throttle.
Caution during operation:
If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min
higher speed than required and at an approximate speed of 6,000 - 8,000 min
).
) and pull the starter rope again until the engine
-1
.
15
(3)
(2)
(1)
(5)
(4)
-1
or more. Never operate the engine at a