Bresser TemeoTrend SQ Instrucciones De Uso página 24

3. Press the CH+ button once again to return
to normal display mode.
Pay attention: With the automatic channel-
change display, the display automatically
switches between the three channels every
4 seconds.
Display of the current indoor and outdoor
temperature
1. Slide the °C/°F switch (Fig. 1, 6) to position
for the desired temperature unit (Celsius or
Fahrenheit).
2. The internal temperature appears in the
display on a permanent basis. The outside
temperature of the connected outside
sensors can be displayed separately or
automatically (read more about this in the
previous chapter).
Pay attention: If a channel is allocated to an
external sensor, after a change of the channel
on the sensor, the RESET button (Figure 2,
13/ Fig. 3, 18) must be pressed. If no signal
is received for a channel, "—-" appears in the
display. In the case of receiver interference,
24
L700X40XMSP1215BRESSER.indd 24
change the position of the weather station or
the outdoor sensor. Ensure that both devices
are located in the optimum operating range
of about 50 meters to each other. If several
attempts fail, remove the batteries from both
devices and initiate the setup again. Try to
establish in which position the weather station
receives the best signal strength.
Display and clear the max/min
temperature values
1. Press the MEM- button (Fig. 1, 4) for around
5 seconds in the display mode to display the
max/min values for the indoor and outdoor
temperature as well as the date/time settings.
2. Press and hold down the MEM/- button
for about 3 seconds, to clear the stored max/
min temperature values.
Pay attention: When resetting the settings or
removing the batteries, all the stored settings
will be cleared!
Frost warning
1. If an outdoor temperature range of
between -2 °C and +3 °C (28 ° F and 37 °
14.12.15 13:2