Kenmore 24 Manual Del Propietário página 20

ice and Water Dispenser
To Use the Dispenser
Press the rim of the glass
gently
against the dispenser pad.
Select CUBED ICE,
CRUSHED ICE (on
some models) or WATER
The spill shelf is not self-
draining. To reduce water
spotting, the shelf and its grille Spil_ Shelf
should be cleaned regularly.
If no water is dispensed when the refligerator is first
installed, there may be air in the water line system.
Press the dispenser pad for at least two minutes to
remove trapped air from the water line and to fill the
water system. To flush out impurities in the water line,
throw away the first six glassfuls of watet:
A light switch (on some models) turns the night light
in the dispenser on or off. The light also comes on
when the dispenser pad is pressed. The light in the
dispenser should be replaced with a 7-watt maximum
bulb when it burns out..
CAUTION: Never put fingers or any other
objects into the ice crusher discharge
opening.
ice Storage Bin
TO REHOVE: Lift the left
corner to free the bin from the
shelf and pull the bin straight
out while supporting it at front
and rear.
TO REPLACE: Slide the bin
back until the tab on the bin
locks into the slot on the shelf:
If the bin does not go all the
way back, remove it and turn
the drive mechanism 1/4 turn.
Then push the bin back again
until the tab on the bin Ioclcs
into the slot on the shelf.
Important Facts AboutYour Dispenser
* Add ice before filling the glass with a beverage.
* Do not add ice flom trays or bags to the storage bin°
It may not crush or dispense welt.
o Avoid overfilling glass with ice and use of narrow
or extra-tall glasses. Backed-up ice can jam the
chute or cause the door' in the chute to freeze shut.
If' ice is blocldng the chute, poke it through with a
wooden spoon.
, Beverages and fi_ods should not be quick-chilled in the
ice storage bin. Cans, bottles or food packages in the
storage bin may cause the icemaker or auger to jam.
, Some crushed ice may be dispensed even though
you selected CUBED ICEo This happens occasionally
when a few cubes accidentally get directed to the
crusher.
* After crushed ice is dispensed, some water may drip
flom the chute,
* Sometimes a mound of snow will form on the door
in the ice chute. This condition is normal and
usually occurs when you have dispensed crushed ice
repeatedly. The snow will eventually evaporate.
* Dispensed water' is not ice coldo For colder water, add
crushed ice or cubes before dispensing water:
External Water Filter Accessory
(optional at extra cost)
Your ice cubes can only be as flesh-tasting
as the water that produces them. That's
why it's a good idea to filter the water
with a water filter,
The water filter is an optional part at extra
cost and is available fl'om your Sears Service
Center° It may be installed in minutes when
attached to the inlet water tube connection.
2O
Water Supply Accessory Kit
(optional at extra cost)
A water supply ldt containing copper tubing, shutoff
valve, fittings and instructions needed to connect the
icemaker to your cold water line is also available from
your Sears store or Sear_ Service Center.