Installing The Filter Cartridge; Setting The Filter Capacity - Philips WP3821/01 Manual De Instrucciones

English
1
 Screw the attachment nut firmly onto the water purifier
housing (Fig. 22).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.

Installing the filter cartridge

1 Make sure the tap is closed.
 Set the water selection lever to the unfiltered stream
position (Fig. 23).
 Tilt the filter cartridge 90° backwards and insert it into the water
purifier housing. (Fig. 24)
 Pull the cartridge upwards until it is in upright position. (Fig. 25)
5 Air trapped inside the filter cartridge affects the flow rate of the
filtered water. To avoid this, slightly open the tap and let water run
through the filter cartridge for 30 seconds after you install/replace
the filter cartridge. The slow stream of water helps to remove any
air trapped in the filter.

Setting the filter capacity

The default filter capacity setting of the water purifier is 1500 litres.
Follow the instructions below to set the filter capacity of your filter
cartridge. The capacity of the filter cartridge supplied with the WP3821 is
2500 litres.
Note: When you replace the filter cartridge for the first time and any next
time, reset the filter capacity as described in section 'How to reset the filter
capacity' in chapter 'Replacement'.
1 Make sure that the water purifier housing and the filter cartridge
are properly installed.
 Press the filter capacity selection button.
The default filter capacity of 1500 litres flashes on the display for
,
4 seconds.