Using The Appliance - Philips WP3821/01 Manual De Instrucciones

 Press the filter capacity selection button again until the display
shows the capacity of your filter cartridge (1500-2500-900-1500
etc.).
 Stop pressing the filter capacity selection button when the display
shows 2500 litres.
The selected filter capacity and the remaining filter capacity are
,
shown for 5 seconds.

using the appliance

1 Turn the water selection lever to the desired setting ('click').
The water selection level has 3 settings: filtered spray, unfiltered spray and
unfiltered stream. See the sections below.
 Open the tap.
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the water selection lever until the filtered spray symbol is
aligned with the indicator (Fig. 26).
Do not let water hotter than 50°C run through the water purifier at
this setting, as this may damage the water purifier.
If you filter water between 35°C and 50°C, the water may have an
unpleasant smell. The filter cartridge has absorbed this smell during
filtering, but releases it again if you filter water hotter than 35°C.
 Open the tap.
Filtered spray comes out of the water purifier.
,
The display is on and counts down the remaining filter capacity.
,
Note: The LCD display only shows the remaining filter capacity when you use
the water purifier at the filtered spray setting and when the water pressure is
more than the minimum required 0.7kgf/cm² (7 meters of water column).
Note: The display is off when you do not use the water purifier and when you
use it at the unfiltered spray and unfiltered stream settings.
English
1