8. Blade Assembly.
Time Saver: Washers for blade attachment
screws can be set on each screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in hardware pack. Slide a blade
through one of the narrow, rectangular
openings on the motor housing, aligning
holes in blade with holes in blade arm,
which is pre-attached to the underside of
the motor housing and located inside the
motor housing--refer to drawing at right.
Insert 3 blade attachment screws (along
with washers) with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade attachment screws
twice a year.
9. Light Kit Assembly (Optional).
Remove 1 screw from motor plate (on underside of
motor) and partially loosen the other 2 screws. Align
slotted holes in fitter plate with loosened screws in
motor plate, allowing female plug from motor
housing to come through hole in middle of fitter
plate. Twist fitter plate to lock. Re-insert screw that
was just removed and tighten all 3 screws securely.
[Refer to diagram 1.]
Remove 1 screw from post on underside of fitter
plate and partially loosen the other 2 screws.
Connect male plug from LED light kit to female plug
from motor housing, matching up the colors on the
male plug with the colors on the female plug for
correct fit. Be sure that plugs connect securely. [Refer
to diagram 2.]
Carefully arrange wiring in center of fitter plate.
WARNING: Do NOT allow wires to remain outside of
posts as this could damage the wires.
WARNING: Make sure wires do not get pinched in
between LED light kit and post(s) on fitter plate. This
could cause damage to the wire(s).
Align slotted holes in LED light kit with loosened
screws in fitter plate. Twist LED light kit to lock.
Re-insert screw that was previously removed and
tighten all 3 screws with a Phillips screwdriver. [Refer
to diagram 2.]
Align grooves on glass shade with nodules on inside
of LED light kit and push up gently on glass shade.
Twist glass shade to the RIGHT (clockwise) until
glass shade no longer turns. [Refer to diagram 2.]
NOTE: The use of rubber grip gloves are recommended
should you need to remove the glass shade.
(view from underside)
blade arm
motor plate
female plug
diagram 1
LED
light kit
diagram 2
page 6
motor housing
blade
blade attachment
screws and washers
fitter plate
motor
housing
fitter plate
female plug
male plug
glass shade