Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This manual is consistent with the date of manufacture
of your machine, you will find information on the
technical data of the machine acquired manual check
for updates of our machines on the website:
www.grupostayer.com
1_INSTRUCCIONES ESPECIFICAS DE
SEGURIDAD
Wear hearing protection. Exposure to noise can
cause hearing loss.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory or fastener may contact hidden wiring.
Cutting accessory and fasteners contacting a "live"
wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
Use appropriate detectors to determine if utility
lines are hidden in the work area or call the local
utility company for assistance. Contact with electric
lines can lead to fire and electric shock. Damaging a
gas line can lead to explosion. Penetrating a water
line causes property damage or may cause an electric
shock.
Switch off the power tool immediately when the
tool insert jams. Be prepared for high reaction
torque that can cause kickback. The tool insert jams
when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
Keep your workplace clean. Blends of materials are
particularly dangerous. Dust from light alloys can burn
or explode.
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
Protect the power tool against heat, e. g.,
against continuous intense sunlight, fire,
water,
and
explosion.
In case of damage and improper use of the battery,
vapours may be emitted. Provide for fresh air
and seek medical help in case of complaints. The
vapours can irritate the respiratory system.
moisture.
Danger
of
-
Safety Warnings for battery chargers
Keep the battery charger away from rain or
moisture. Penetration of water in the battery charger
increases the risk of an electric shock.
Do not charge other batteries. The battery charger is
suitable only for charging STAYER lithium ion batteries
within the listed voltage range. Otherwise there is
danger of fire and explosion.
Keep the battery charger clean. Contamination can
lead to danger of an electric shock.
Before each use, check the battery charger, cable
and plug. If damage is detected, do not use the
battery charger. Never open the battery charger
yourself. Have repairs performed only by a
qualified technician and only using original spare
parts. Damaged battery chargers, cables and plugs
increase the risk of an electric shock.
Do not operate the battery charger on easily
inflammable surfaces (e. g., paper, textiles, etc.)
or surroundings. The heating of the battery charger
during the charging process can pose a fire hazard.
Children should be supervised to ensure that they
do not play with the battery charger.
2_INSTRUCTIONS FOR USE
PLACEMENT TOOL
Read
all
instructions.
Failure
to
instructions may result in electric shock,
fire and/or serious injury.
ASSEMBLY (FIG. B)
Before any work on the machine (e. g., maintenan-
ce, tool change, etc.) as well as during transport
and storage, set the rotational direction switch to
the centre position.
Unintentional actuation of the On/Off switch can lead
to injuries.
Battery Charging
Do not use other battery chargers. The supplied
battery charger is designed for the Lithium- Ion battery
in your machine.
Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the
nameplate of the battery charger. Battery chargers
marked with 230 V can also be operated with 220 V.
The battery is supplied partially charged. To
ensure
full
completely charge the battery in the battery
charger before using your power tool for
the first time.
15
-
safety
warnings
and
follow
the
warnings
capacity
of
the
battery,
es
it
gb
all
and
Publicidad
Tabla de contenido
