JANE Sweet Instrucciones página 12

- Do not leave objects inside the carrycot that could
cause suffocation. P.eg: pillows or stuffed animals.
- Do not leave the carrycot near ribbons or curtain
ropes.
- Overheating can be dangerous for your baby. Take
into account the ambient temperature and the
clothing you are wearing to ensure that you are not
too cold or too hot.
- Ask your health professional for tips on how to sleep
safely
C. UNFOLDING
1A
Place the SWEET folding carrycot on a flat surface .
A_ Turn the ProFix adaptors outwards 1B
B_ Pull the folding straps under the carrycot outwards until the
frame locks and the side walls fully unfold. 1B
Make sure that the walls are fully unfolded!
22
EN
D. FOLDING
2A
Fold the hood. Close the foot cover.
A_ Pull the folding straps under the carrycot towards the centre..
B_ Fold in the ProFix adaptors. 2B
WARNING: This step must never be done with the baby insi-
!
de the carrycot. It is inevitable that sharp points and areas
where body parts could get trapped emerge during these
operations.
E. RECLINING BACKREST
The back of the carrycot can be reclined so the baby can enjoy more
of a sitting up position.
3A
To raise it, pull the side strap upwards . Once you have pulled it as
far as it will go, slowly release it until it locks into place 3B . Check that it
is firmly locked into place.
To move it back to the lying down position, pull the central strap
The mechanism will unlock and you can gently release it back to the
lying down position 3D .
F. USING THE HANDLE AND THE HOOD
This carrycot is fitted with a central handle for carrying. The handle is
also used as a support for the hood.
The handle can be rotated to fold the hood. To rotate it, press the two
buttons on the sides. When you release the buttons, the hood will be
5A
locked into the nearest position.
If you are using it as a carry handle, make sure that the handle is in the
2B
upright position and is properly locked in place.
The hood can be folded, unfolded and removed.
To fit the canopy, place both flaps around the handle and close
the snaps on the inside of the handle. The skirt is attached to the
carrycot with velcro. For greater ventilation and to be able to see
the child, the hood has an extra section made of mosquito netting:
you can access this section by undoing the zip between the first
and second sections of the hood.
To remove the hood, follow the same steps in reverse.
!
WARNING: Do not place any weight on top of the hood.
3C
G. FOOT COVER AND CARRYCOT COVER
To settle your baby, undo the zip of the footmuff to the required level.
4A
The cover has a ventilation window over the baby's head. Open the two
zippers to make it accessible. The skirt can be rolled up and held open
4B
with two snaps.
H. ATTACHING THE CARRYCOT TO A JANÉ PUSHCHAIR
.
To attach the carrycot to a Jané chassis, position the carrycot so
that the child's head is facing away from the handlebar.
Fitt the ProFix adaptors into the side housings of the chassis; you
should hear them click into place.
CAUTION! Before use, make sure that all the safety locks are
fastened.
Fitt the ProFix adaptors into the side housings of the chassis; you
should hear them click into place.
To prevent any possible swinging, when fitting the carrycot over the
chair, you can anchor the tension strap using the pivot under the
handlebars. 7A
Adjust the tape to tighten it.
!
NOTE: release the tension strap before removing the carrycot
6A
6B
7B
EN 23