Publicidad
Idiomas disponibles
Idiomas disponibles
[]
CHANGE
CODE
4 Display the "CHANGE CODE" screen.
,, Using [CH A/T'] on the remote control, select
"CHANGE CODE".
TV RATING
MRAA RATING
_*CHANGE CODE
,, Press [VOL A] on the remote control.
5 Change the access code.
,, Use Channel number
buttons on the remote
control and enter the NEW 4-digit CODE.
,, Enter code again in CONFIRM CODE box.
NEW CODE
CONFIRM CODE
6 To exit the menu, press [MENU] on the remote
control.
NOTES:
• Make sure to enter the exact same new code in the "CON-
FIRM CODE" space as one in the "NEW CODE" space, If
they are different,
the "NEW CODE" space is cleared for
reentering.
• Yourpersonal
access code will be erased and return to the
default (OOOO)when a power failure occurs or when you turn
off the power using a wall switch, ff you forget the code,
unplug the power cord for 10 seconds to restore the access
code to 0000.
The SLEEP TIMER function will automatically turn
off the power of the unit at a preset time.
uu
(]D CD (_:)
CD CD (:D
GD _
(])
6 Qo
SLEEP
CD _C
_E_b
_[uz T
SLEEP _
1 Use SLEEP TIMER.
,, Press [SLEEP]
on the remote control.
,, The setting display for SLEEP TIMER is shown
in the screen.
SLEEP 0
2
Set the timer.
,, Every time you press [SLEEP] on the remote
control, the time increases by 10 minutes.
,, You can set the timer up to 90 minutes.
,, After setting, you can check the remained time
per 1 minute by pressing [SLEEP].
SLEEP 16
NOTES:
• When you disconnect
the unit from the AC outlet or when a
power failure occures,
the sleep timer setting
will be can-
celed.
• To cancel the sleep timer, press [SLEEP]
on the remote
control repeatedly until "SLEEP 0" is displayed.
• The Sleep Timer setting display will automatically
disappear
after
10 seconds.
EN
Publicidad
