Publicidad
Idiomas disponibles
Idiomas disponibles
ill iii iiiiiiiiiiiiii
This section describes how to connect this TV to reception and other sources.
[ANTENNA
/ BASIC CABLE CONNECTION]
When connectinq TV to antenna
*For digital signal
1) Connect the RF cable or antenna cable on your home outlet to the ANT. IN jack of this TV.
LLI
t.t)
t_
O
Z
O
t_
I.LI
O..
09
I'--
Z
ILl
li
Z
O
O
When connectinq TV to basic cable (without box) *For analog reception
only
1) Connect the RF cable or incoming cable on your home outlet to the ANT. IN jack of this TV.
NOTES:
* Foryour
safety and to avoid damages
to the unit. unplug the antenna
cable from the ANT IN jack before moving the unit.
. If you use an antenna
in order to receive
analog TV, the same antenna
generally
will work for DTV reception.
Outdoor
or attic antennas
will be more
effective
than set-top
versions.
. Some cable channels
cannot be viewed when the TV is connected
to an aerial antenna because
DTVprogram
does not cover all
cable channels.
You can watch them by switching
to the cable connected
to CATV.
. To easily swith between
antenna and cable wires, you can purchase
"Antenna Selector" commercially
available.
*Once connections are completed, turn on the TV and begin initial setup.
Channel scanning is necessary for the TV to memorize all available channels in your area if using antenna
or basic cable. (Refer to "INITIAL AUTO PRESET" on page 13.)
EN
Publicidad
