Ego Power+ PAD1800 Manual Del Operador página 14

 To turn on the LED light, press the LED button. The light will turn on in low brightness
mode.
 Press the LED button again to switch to high brightness mode.
 Press the LED button the third time to switch LED light off.
In any mode, press and hold the LED button for more than 1 second and the light will
switch into flashing, "EMERGENCY" mode. Press the LED button again, the light will
shut off.
POWERING EXTERNAL DEVICES
1. Install a battery pack onto the power inverter.
2. Press the power button to turn on the power inverter. The LED in the power button
will glow solid green, which means the power inverter is ready for supplying power.
3. Connect devices into the power inverter's USB ports and/or 120V AC output port. The
inverter will begin powering the devices automatically.
4. When the power inverter is not in use, disconnect devices from the power inverter,
then press the power button to turn off the power inverter.
5. Remove the battery pack from the power inverter.
14
56-VOLT POWER INVERTER — PAD1800/PAD1800-FC