Publicidad
Idiomas disponibles
Idiomas disponibles
UntitledBook1.book Page 12 Thursday, July 12, 2007 6:08 PM
Do not use the appliance over the power supply cord.
1 Check that the dust-bag container (19) and filters (23 and 25) are fitted
correctly. See the following section (Cleaning and Maintenance).
2 Fit the flexible hose (7), placing the fitting (6) in the bag compartment
opening (5), until you hear a click. To remove the hose, press the detach
latches (8), turn and pull on the fitting.
3 Prepare the accessories that correspond to the surface you desire to
clean. They snap on with a gentle turn. The attachments can be placed
directly on the flexible hose (7) or, for out-of-reach places, the telescopic
metallic tube (11) can be used.
• The suction brush (13) on these models can be used for all types of
floors, carpets and rugs. This brush is retractable so it adapts to the
surface to be vacuumed. To change the cleaning position of the brush,
press the brush button (14) with your foot (fig. 3). We recommend
cleaning hard floors, wood and parquet with the fibre brush enabled, and
cleaning carpets and rugs with the fibre brush retracted.
• This model is supplied with a vacuum nozzle for narrow places, grooves
and corners (15) that can be placed directly on the flexible hose (7) or
the telescopic metal tube (11).
• The length of the telescopic tube (11) can be changed by moving the
adjustment button (12) while moving both parts of the telescopic tube.
4 Pull out the cord (2) to the yellow mark (ideal length). If necessary, the
cord can be pulled out to the red mark, but not any further.
5 Place the operating and regulating knob (16) at the MIN position and
plug into the mains.
6 Switch the vacuum cleaner on by pressing the control knob (16) and
regulate the motor power by turning the knob (do not press the kob,
because this will switch off the vacuum cleaner).
Notice that the knob (16) has both the on/off function (by pressing) and
the motor power regulating function (by turning).
7 Suction power can also be adjusted by opening or closing the
mechanical power regulator on the handle (10).
8 When finished, switch the appliance off by pressing the ON/OFF button
(16). Unplug it and press the button (18) on the handle to wind up the
cord. Hold the cord plug in your hand to prevent it from banging against
the vacuum cleaner housing.
9 The handle (18) can be used to carry the vacuum cleaner.
12
Use
Publicidad
