Publicidad
Idiomas disponibles
Idiomas disponibles
UntitledBook1.book Page 13 Thursday, July 12, 2007 6:08 PM
4 Cleaning and Maintenance
Changing the dust-bag (19)
When the indicator (17) is completely red, a new paper bag must be
installed in the vacuum cleaner.
• This indicator may show red if something is stuck in the flexible hose or
in an attachment. To find out if that is the case, unplug the vacuum
cleaner, remove the flexible hose, and turn the vacuum cleaner on again.
If the indicator does not show red, clean the flexible hose and its
attachment.
• To change the paper bag, unplug the vacuum cleaner and proceed as
follows:
1 Open the bag compartment by pressing on the latch (4) and lifting the
cover (fig. 1).
2 Remove the plastic base (20) and the bag (19).
3 Press the tab (21) and separate the base while holding the bag by the
carton (fig. 4). Do not crumple the bag, as this may expel the dust inside.
4 Place the new paper bag inside the plastic base (20) and lower the notch
(22).
5 Place the base with the new bag (fig. 5) in the compartment and make
sure that it fits tightly.
6 To close the compartment (2), lower the cover and press down on the
opening space with your hand (1), until you hear a click (fig. 2).
It is very important that the bag be placed correctly.
Changing the motor protection filter (23)
We recommend that you check the motor protection filter regularly to
make sure that it works properly. This will rule out that poor placing of the
filter or of the dust-bag, or tears or leaks in the bag obstruct the appliance
and reduce suction capacity.
Replace the motor protection filter every 6 changes of the dust-bag.
1 Open the dust-bag container by pressing on the latch (4), and lifting the
cover (fig. 1).
2 Remove the plastic base (20) and the bag (19).
3 Remove the filter by pulling the top upward (fig 6).
4 Insert the new filter, making sure that it is properly placed and fits tightly
in the top rubber seal.
Cleaning and Maintenance
en
13
Publicidad
