Descargar Imprimir esta página

Sony DSC-1024HD Manual De Instrucciones página 44

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Connection example
Personal
computer,
workstation,
etc.
VIDEO 3 IN
rsa 0Fem
ce | 68
—THEQUGH
rslLloren Qj
<=
Black burst signal
Betacam SP video cassette
recorder (for playback)
REF
VIDEO iN
REF
VIDEO IN
Betacam SP video cassette
VIDEO OUT
recorder (for recording)
VIDEO 1 IN
REF
Signal generator, etc. (to supply
black burst signal)
The output NTSC or PAL signal can be synchronized using the
black burst signal input from a signal generator, etc. as a
reference signal (gen-lock).
This enables smocth editing without transition noise when
multiple video sources are used.
Activating the generator lock
1
Input the reference signal which corresponds with the
output signal format (NTSC or PAL) from the editor or
signal generator to the VIDEO 1 IN REF connector.
2° Press the MENU button twice.
The MENU 2 screen appears.
MENU 2
MENU
»SETUP NTSC
GEN LOCK
SC/H ADJ
4080' 60:59.94
USE-GOENTER
EXIT: MENU
3
Press the CENT 0/¢ button to move the cursor (>) to
GEN LOCK, and press the ENTER button.
The GEN LOCK screen appears.
GEN LOCK
Orr
ON
USF
QGP NTE
CANCEL
M?
NU
4
Press the CENT ¢@/¢ button to move the cursor (>) to
ON, and press the ENTER button.
The gen-lock is activated for the signal output from this
unit and the GEN-LOCK indicator on the front panel
lights.
When the converter is turned on or the input mode is
changed, "GEN LOCK MODE" appears on the screen.
VIDEO2
GEN LOCK MODE
315k ® NTSC
To deactivate the generator lock
Repeat steps 1 to 3 above, then set GEN LOCK to OFF in step
4. The GEN-LOCK indicator on the front panel turns off.
¢ If you select GEN LOCK on the MENU 2 screen with no
reference signal input, "NO REFERENCE" appears on the
screen
¢ "WRONG
REFERENCE" will appear when the reference
signal format does not correspond with the input signal
format.
¢ The RGB/component output is recommended for editing. It
you use the composite video output, a frame synchronizer
may be needed to adjust the phase to the reference signal
For the SC/H (Subcarrier to Horizontal) adjustment, see
page 46>

Publicidad

loading