7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure,
you operated the hob correctly. If not the
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob,
write down the serial number
(Ser. Nr) from the rating
plate. The rating plate is on
the bottom of the hob.
ELECTROLUX
EQG4120BOZ
Typ 55 FED 04 GA 220 - 240 V
Gas type: G20 2H
- 20 mbar
Butane (G30 28 -
30 mbar): 342 g/h
Propane (G31 37
mbar): 336 g/h
Ser.Nr. .................
8.2 Gas Connection
WARNING!
The following instructions
about installation,
connection and maintenance
must be carried out by
qualified personnel in
compliance with standards
and local regulations in
force.
Make sure that during the installation the
appliance is not connected to electrical
supply. Disconnect the mains plug or
PNC 941 460 017
00
50 - 60 Hz
PIN 0063CL3461
Qn (Hs): 4.9 kW
servicing by a service technician or
dealer will not be free of charge, also
during the warranty period. The
instructions about the Service Centre
and conditions of guarantee are in the
guarantee booklet.
deactivate the fuses. Disconnect the
mains gas supply.
Make sure that there is a stop tap
assembles between the gas supply of
house and the appliance.
The settings for this appliance are
located on the rating plate. The present
settings for the type of gas and gas
pressure are on a sticker.
Choose fixed connections or use a
flexible pipe in stainless steel in
compliance with the regulation in force. If
you use flexible metallic pipes, be careful
they do not come in touch with mobile
parts or they are not squeezed. Also be
careful when the hob is put together with
an oven.
This appliance is not connected to an
exhaust gas outlet. It must be connected
in accordance with the installation
conditions that apply. Pay special
attention to correct airflow.
Make sure that the gas
supply pressure of the
appliance obeys the
recommended values. The
adjustable connection is
fixed to the comprehensive
ramp by means of a
threaded nut. G 1/2". Screw
the parts without force,
adjust the connection in the
necessary direction and
tighten everything.
ENGLISH
11