Publicidad
Idiomas disponibles
Idiomas disponibles
EN
! CAUTION: Using the GRABO® Pro-Lifter 20 while the battery is low may result in injury and
FR
damage to the materials being lifted. It is advisable to fully charge the battery before using the
ES
GRABO® Pro-Lifter 20.
2. As an option, press the measurement unit selector Ⓕ to change the pressure unit
measurement from bar to psi and weight units from kg to lbs.
3. Position the GRABO® Pro-Lifter 20 firmly against the surface of the object you want to lift.
4. Press the green motor power button Ⓒ . The run status indicator Ⓖ flashes red. A seal is
created within seconds. When the negative pressure reaches the maximum level, the run status
indicator Ⓖ turns green and the motor stops automatically.
5. Lift and move the object.
! When lifting materials with dusty, dirty, or moist surfaces, remove the dust and dirt as much as
possible. The GRABO® Pro-Lifter 20 will automatically turn the pump on and off to maintain
the pressure necessary for safe lifting.
! For maximum safety, switch the display to weight units (kg/lbs) and compare the displayed
values with the weight being lifted, based on the "Maximum lifting force" table.
Do not try to lift any weights heavier than the value displayed.
TO END OPERATING THE GRABO® PRO-LIFTER 20
1. When you are done and the object is in a secure and stable position, press the green motor
power Ⓒ button to stop the vacuum pump. Press the red vacuum release button Ⓑ to break
the seal and release the object.
CHARGING AND CHANGING THE BATTERY ❼
Charge the battery when the capacity is low or the battery is empty.
CAUTION: Use the GRABO® Pro-Lifter 20 only with the original Li-ion 2600 mAh battery
(article number TB05000) and the original multi-socket battery charge (article number SP94112).
1. Slide the battery latch to unlock the battery Ⓐ .
2. Remove the battery.
3. Connect the battery with the multi-socket battery charger to a wall socket.
4. When the battery is fully charged, the battery bar indicator Ⓠ turns green.
5. Disconnect the multi-socket battery charger from the wall socket and battery.
6. Put the battery in the battery compartment.
7. Press and slide the battery latch to lock the battery.
! During the process of charging, the charger can become warm: this is normal.
! Only use the charger in a dry environment. The charger is not waterproof.
! Ensure that the power supply voltage corresponds to the data on the nameplate of the battery
charger.
! Keep away from flammable objects while charging.
20
Publicidad
