Publicidad
Idiomas disponibles
Idiomas disponibles
EN
NOTICE: The GRABO® Pro-Lifter 20 will display incorrect values on the digital display if the device
FR
is not calibrated on a non-porous surface such as tile or glass. In this case the calibration process
ES
must be repeated on a non-porous material. DO NOT perform this process on glass that is thinner
than 6 mm. Glass thinner than 6 mm may be damaged.
DISPOSAL
Do not dispose of electric equipment, batteries, accessories, and packaging in domestic waste.
Electrical equipment that has reached the end of its life shall be collected separately and returned
to an environmentally compatible recycling facility.
SPARE PARTS
Name
GRABO® Pro-Lifter 20
Battery
Multi-socket battery charger
Rubber foam seal
Fabric bag
DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product, the GRABO® Pro-Lifter 20, Model No.
NG-Pro-14.8-2Li and GP-1Li-FB-1S, is in conformity with the requirements set up by regulation for
the evaluation of electromagnetic compatibility.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
This declaration is the responsibility of the manufacturer/importer NEMO POWER TOOLS LIMITED,
21st Floor, CMA Building 64 Connaught Road Central Hong Kong, PRC
Identification of regulation: 47 CFR Part 15 Subpart B
l
Measurement Procedure: ANSI C63.4: 2014. It is only valid in connection with the test report
l
number: TCT211130E019.
Test laboratory: This is the result of the test that was carried out from the submitted type-
l
samples of a product in conformity with the specification of the respective standards.
Authorized Signer: Nimo Rotem
l
Date: Jan. 06, 2022
l
24
Article number
GP
TB05000
SP94112
RK13001
SN23017
Publicidad
