Makita KP312 Manual De Instrucciones página 5

Foot
► 1. Rear base 2. Foot 3. Planer blade
After a cutting operation, raise the back side of the tool
and a foot comes under the level of the rear base. This
prevents the tool blades to be damaged.
Guideline of cutting blade passage
1
► 1. Front base
Both ends of the front base are a guideline to show the
ends of cutting blades passage.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
1
3 2
Removing or installing planer
blades
► 1. Socket wrench 2. Installation bolt
CAUTION:
• Tighten the blade installation bolts carefully
when attaching the blades to the tool. A loose
installation bolt can be dangerous. Always
check to see they are tightened securely.
• Handle the blades very carefully. Use gloves
or rags to protect your fingers or hands when
removing or installing the blades.
• Use only the Makita wrench provided to remove
or install the blades. Failure to do so may result
in overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
To remove planer blades from the drum, loosen the
eight installation bolts by only one full turn with the
socket wrench.
Then push and slide a planer blade sideways from the
belt side using the helm of the socket wrench.
To remove another planer blade, follow the same proce-
dure as above.
► 1. Socket wrench
5 ENGLISH
1
2
1