Makita KP312 Manual De Instrucciones página 7

Blade height adjustment
1
3
► 1. Drum plate 2. Installation bolt 3. Set plate screw
4. Set plate 5. Planer blade 6. Adjusting screw
7. Drum
Blade height adjustment is usually not necessary.
However, if you notice that the blade edge is below the
level of the rear base or protrudes too far from the rear
base, proceed as follows.
Loosen the eight installation bolts and the set plate
screws. Turn the adjusting screws clockwise to retract
the blade or counterclockwise to protrude it. After
adjusting the blade height, tighten the set plate screws
and the eight installation bolts securely.
Socket wrench storage
► 1. Socket wrench 2. Wrench holder 3. Rear base
When not in use, store the socket wrench as shown in
the figure to keep it from being lost.
Nozzle assembly and joint (optional
accessory)
2
4
5
6
7
► 1. Chip guide
Nozzle assembly and joint are used when connecting
the tool to vacuum cleaner.
When you wish to perform cleaner operation, connect a
vacuum cleaner to your tool.
To connect vacuum cleaner, remove the chip guide from
the tool. Place nozzle assembly and joint in its place
and then tighten screws to secure them.
2
1
1
► 1. Joint 2. Nozzle assembly
2
Connect a hose of vacuum cleaner to the joint.
3
7 ENGLISH
1