Publicidad
Idiomas disponibles
Idiomas disponibles
Power Supply
FUNCTION
BAIT
IMPORTANT
Make sure that FUNCTION is set to (!) STANDBY
POWER/
TAPE before connecting the AC cord or inserting batteries.
Before connecting
the AC cord (LH model only)
Check that the rated voltage shown on the
rear panel matches your local voltage. To
match your local voltage, switch the AC
VOLTAGE selector (AC 11O-120/220-240 V,
~jm;.fi=
;~21;-
switchable) in the battery compartment
with
AC VOLTAGE
a screwdriver
or similar
tool.
Connect the AC cord as illustrated below.
it
+
Q
to an
AC
outlet
~
AC
VOLTAGE
(LH model only)
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Open the lid of the battery compartment
on the rear and
insert eight RI 4 (size C) batteries, not supplied, as illustrated
below. Then close the lid.
c Before using on batteries, disconnect the AC cord from the
AC inlet. Battery power is cut off automatically
when the
cord is connected.
@
o
R14 (c)
The batteries need to be replaced when:
The OPE/BATT
indicator becomes dim, the tape speed
slows down, volume decreases, or sound is distorted during
operation.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
Insert the batteries with the 0 and ~ marks correctly
aligned.
Do not mix different types of batteries or old batteries with
new ones.
Never recharge the batteries, apply heat to them or take
them apart.
Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent
solution. Do not use strong solvents such as qlcohol,
benzine or thinner.
To clean the heads and tape
paths
After every 10 hours of use,
clean the heads 0 and 0, the
pinchroller @ and capstan ~.
Use a cotton swab @ slightly
moistened with cleaning fluid
or denatured alcohol.
To clean the lens
Lens
Use a cotton swab slightly
moistened with cleaning fluid.
fir+>
Wipe gently from the c&ter
to
the edge.
>1%
2
Publicidad
