Publicidad
Idiomas disponibles
Idiomas disponibles
FUNGI IUN
I
'-,rmmrw
I
1A
,, -,.... —
I
J
f
.
L1,,,,,,
m
H
f+=c
PLAY
REW
F WD STOP/EJECT PAUSE
I
1
2
3
4
Set FUNCTION
to CD.
Press
OPEN
mark to open
the
disc
compartment
and place a disc with the
printed
side
up.
Press
Wll
PLAY/PAUSE
to start play.
The track number
is displayed.
"1" indicates
that the 1st track is playing,
and "O 1"
indicates
the 11th track. "1" and a flashing
"o"
indicate
the 21st,
31st ... 91st
track.
Turn VOLUME
and TONE
to adjust
the sound.
9 STOP - Stops play.
/11 PLAY/PAUSE
– Pauses play. To resume play, press
again.
1+,
M
SKIP/SEARCH
– Searches for a particular point
during playback. Keep M
or -
pressed and then
release it.
– Skips to the beginning of a track. Press l++
or M
repeatedly.
REPEAT – Repeats a single track or all tracks. Select as
follows.
The REPEAT indicator flashes: A single track is played
repeatedly. Select a track with 1+4 or M.
The REPEAT indicator lights up: All tracks are played
repeatedly.
NOTE
. Do not place more than one disc in the disc
compartment.
Do not try to open the disc compartment
during play.
Do not touch the lens. Doing so may cause malfunctions.
3
1
Set FUNCTION
to RADIO.
2
Select
a band with BAND.
~
Tune
to a station with
TUNING.
~
Turn VOLUME
and TONE
to adjust
the sound.
For better reception
F
Extend the FM antenna and
AM antenna is inside the
orient it for the best reception.
unit. Position the unit for
the best reception.
FM MODE/OSC
- Sets the FM sound to stereo or monaural.
ST: Reception is stereo. During stereo reception, the FM
STEREO indicator lights up.
MONO: When an FM stereo broadcast contains noise, set
to MONO. Noise is reduced, although reception is
monaural.
- If a high-pitched
sound is heard during recording from
AM, set
this switch
to another
position.
NOTE
if
the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent
lights, move the unit away.
To turn off the unit, set FUNCTION to (!) STANDBY
POWER so that the OPE/BATT
indicator goes out.
To listen with the headphones,
connect headphones
with
a stereo
mini plug to the Q jack.
If an erroneous display or malfunction
occurs, disconnect
the AC cord and remove all the batteries to turn off the
display. Then turn the power back on.
Publicidad
