Publicidad
Idiomas disponibles
Idiomas disponibles
Playing non-standard records and making adjustments
In order to perform program record play, direct song
selection, and forward and backward skip functions
properly, this unit is designed so that the stylus is
lowered
shortly
before
(about
0.5
mm)
the
beginning of the gap between songs. Because of
this, no sound is heard for about ten seconds after
the stylus contacts the record when using one of the
above functions.
Remove
the cap
Record size selector
Sensitivity selector
Speed selector
@OO
Programmed song
y y y
1. Adjusting the tonearm lowering position
The stylus set-down adjustment knob is properly set at the
factory. However, if it has been jarred loose during shipment,
the tonearm may be lowered too far to one side as shown in the
diagram to the right. If necessary,
correct the problem
as
described below.
Gap between songs
about 0.5 mm
® Tonearm towered too far to the left.
Proper location
© Tonearm lowered too far to the right.
Problem
® Tonearm lowered too far to the left
®No sound is heard even when the stylus reaches the
beginning of the specified song.
© Tonearm lowered too far to the right
®No sound is heard for a long time (more than 30
seconds) after the stylus contacts the record.
©The tonearm lowering position for the first song of a
record cannot be adjusted. Adjustment is possible only
for songs 2 through 8.
°\f gaps between songs are extremely short or contain
music or when an eccentric record is used, the
problem cannot be corrected by this adjustment.
Confirmation/Adjustment
@ Set sensitivity selector to H.
@® 'f beginning of song is cut off during program
record
play:
Point where sound begins.
}
Programmed song
Gap between songs
$$
@® Rotate knob in the OUT direction (to the right).
Note:
Always return the sensitivity selector to M after completing
the above adjustment.
@® Set sensitivity selector to H.
@® If the end of the song before the programmed song is
heard.
Point where sound begins.
i
oe
Programmed song
Gap between songs
<——-______J
@® Rotate knob in the IN direction (to the left).
Note:
Always return the sensitivity selector to M after completing
the above adjustment.
aati
Publicidad
