Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATION
OF THE AiR
COMPRESSOR
•
Locate the air compressor
in a
clean, dry, and well ventilated
area.
Place on a solid surface to pre-
vent rocking or tipping.
The air compressor
should be
located at least 12" (30.5 cm)
away from the wall or other
obstructions
that will interfere
with the flow of air.
The air filter must be kept clear of
obstructions
which could reduce
air flow to the air compressor.
The air compressor
requires
fresh air flow for proper cool-
ing. DO NOT ALLOW THE
COMPRESSOR
TO GET WET.
GROUNDING INSTRUCTIONS
RISK OF
--
ELECTRICAL
SHOCK.
in the event of a short
circuit, grounding
reduces the risk
of shock by providing an escape
wire for the electric current. This
air compressor must be properly
grounded.
The portable air compressor is
equipped with a cord having a ground-
ing wire with an appropriate grounding
plug (see following illustrations).
The
plug must be used with an outlet that
has been installed and grounded in
accordance with all local codes and
ordinances.
1.
The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.
iMPORTANT: The outlet being used
must be installed and grounded in
accordance
with all local codes and
ordinances.
2,
Make sure the outlet being used
has the same configuration
as the
grounded plug. DO NOT USE AN
ADAPTER. See illustration.
Plug
Grounding Pin
Grounded
Outlets
3.
Inspect the plug and cord before
each use. Do not use if there are
signs of damage.
4.
If these grounding instructions are
not completely understood, or if in
doubt as to whether the compres-
sor is properly grounded, have the
installation checked by a qualified
electrician.
RISK OF
--
ELECTRICAL
SHOCK. iMPROPER GROUNDING
CAN RESULT IN ELECTRICAL
SHOCK.
Do not modify the plug provided. If
it does not fit the available
outlet, a
correct
outlet should be installed by
a qualified electrician.
Repairs to the cord set or plug
MUST be made by a qualified
electrician.
EXTENSION
CORDS
Using extension cords is not
recommended.
The use of extension
cords will cause voltage to drop
resulting in power loss to the motor
and overheating.
13-ENG
1000003598
Publicidad
