LEVEL WASHER
iMPORTANT:
Level washer
properly
to reduce
excess noise
and vibration.
Excessive
Weight
Hazard
Use two or more people
to move and install washer/dryer.
Failure to do so can result in back or other
injury.
1. Move the washer
to its final
location.
Place a level on top
edges of washer.
Use side seam as a guide to check
levelness
of sides. Check levelness of front
using lid, as shown. Rock
washer
back and forth
to make sure all four feet make solid
contact
with floor.
HELPFUL TiP: You may want to prop up front
of washer
about
4" (102 ram) with a wood
block or similar
object
that will support
weight
of washer.
Models with
plastic feet
Place level here
Place level here
or
Models with
metal feet
Jam nut
3. On models
with
metal feet, when washer
is level, use a
9/16"
or 14 mm open=end
or adjustable
wrench
to turn jam
nuts counterclockwise
on leveling
feet tightly
against
washer
cabinet.
Not Level
LEVEL
Not Level
2. On models
with
metal feet, use a 9/16"
or 14 mm open-end
or
adjustable
wrench
to turn jam
nuts clockwise
on feet until they
are about
1/2"
(13 mm) from the washer
cabinet.
Then turn the
leveling
foot clockwise
to lower the washer
or counterclockwise
to raise the washer.
On models
with
plastic
feet, use adjustable
pliers to turn the
plastic
leveling
foot counterclockwise
to lower the washer
or
clockwise
to raise the washer.
On all models,
recheck
levelness
of washer
and repeat
as needed.
Jam nut
INSTALLING COIN SLIDE AND COIN BOX
The coin slide mechanism,
service door
lock and key, and coin box
loci< and key are not included
with
some models,
but can
be obtained
from
the usual industry
sources.
Remove the service
door of the meter case by lifting
it up at the
back.
Install the money-accepting
device.
(Refer to manufacturer's
instructions
for proper
installation.)
For washer
using coin slides, use the adapter
kit supplied
with the
washer.
Install a lock and cam on the meter case service door.
Install the
coin vault with lock and key in the meter case opening.
12