Publicidad
Idiomas disponibles
Idiomas disponibles
Generac,° <abe, °d ct
Hi0h' es u eW
• Hang the high pressure hose on the hook attached to
the accessory tray on the left side of the unit as shown
on page 4.
How
to
Use the Nozzles
,_
CAUTION!
Never exchange nozzles without
locking the safety latch on the trigger.
The quick-connect on the nozzle extension allows you to
switch between five different nozzles. The nozzles vary the
spray pattern as shown below (Figure 19).
Follow these instructions to change nozzles:
• Engagethe safety latch on the spray gun.
• Putl back the collar on the quick-connect and pull the
current nozzle off. Store the nozzle in the space
provided on the handles storage panel.
NOTE: For a more gentle rinse, select the white 40° or
green 25° nozzle. To scour the surface, select the yellow
15° or red 0 ° nozzle. To apply chemical, select the black
nozzle.
• Putl back on the collar,insert the new nozzle and release
the collar. Tug on the nozzle to make sure it is securely
in place.
• For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from the cleaning surface. If
you get the spray nozzle too close, you may damagethe
cleaningsurface.
Cleaning
and Applying
Chemical
CAUTION!
You must attach all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON witl damage
the pump.
IMPORTANT:
Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent follow these steps:
• Review the use of the nozzles.
• Prepare the detergent solution as required by the
manufacturer.
• Hang the detergent solution on the "J" hook attached to
the accessory tray, as shown in Figure20.
• Place the small filter end of the detergent siphoning tube
into the detergent
container.
Low Pressure
Black
25 °
High Pressure
White
Green
Yellow
Red
40°
25°
15 °
0°
/
I0
Publicidad
