Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 2,500 PSIHigh Pressure Washer
NOTE:
If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.
• Move the choke lever to the "Closed" position
(Figure 16).
Closed
NOTE:
For a warm engine, be sure the choke lever is in
the "Open"
position.
• Set the engine switch to the "On"
position
(Figure 17).
Engine Switch
Grasp starter
grip and pull slowly until you feel some
resistance.
Then
pull cord out with rapid full arm stroke.
Let rope return slowly. Do Not
let rope "snap back"
against starter.
• If the choke Jever has been moved to the "Closed"
position to start
the
engine,
gradually move
it to
the
"Open"
position
as
the
engine warms
up.
How
to
Stop
Your
Pressure
Washer
• Move the throttle
lever to the "Slow"
position.
• Wait for the engine to idle down.
• Move the engine switch to the "Off'
position.
• Simply shutting off the engine will not release pressure in
the system. Squeeze
trigger
on the spray gun to
relieve
pressure
in the hose.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension
and quick connect nozzles, and
slots to hold the cleaning solution
bottle and the detergent
siphoning filter. There are also two hooks at the ends of
the handle to hold your spray gun and high pressure hose.
NOTE:
The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle extension through the hole on the
accessory
tray, as shown in Figure 18.
• Hang your chemical solution bottle on the "J" hook and
place the detergent siphoning filter in the last slot on the
left (Figure 18).
• Place the spray gun on the hook attached to the
accessory tray on the right side of the unit (Figure 18).
/
9
Publicidad
