Publicidad
Idiomas disponibles
Idiomas disponibles
Use and Care
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE HOOD
For satisfactory use of your hood, become familiarwith the various functions of the
hood as described below
Figure 7
Suction power
2 LED, this led
is
ON
when
suction power
2 is selected.
\
\
Motor OFF button
\
\
\
\
\
\
\
f
f
ON button and
motorsuction
/
power selection
button 1, 2, 3, 1,....
Suction power
1 LED, this led
is
ON
when
suction power
1 is selected.
\
\
\
\
\
\
iiiiii
Suction power
3 LED, this led
is
ON
when
suction power
3 is selected.
Light OFF button
\\
\
\
\
\\
\
\
\
\
\\
\
\\
Intensive
Suction power
LED, this led is
ON when
the
intensive
suction power
is selected.
Light ON button
Intensive
Suction power
button
- this
suction power
will function for
10 rains, then
the hood
set
again
the
preselected
speed
Grease
Filter
Saturation
LED
The Suction power 2 LED is marked with an F. This LED will flash to remind you when the grease filter needs to be cleaned
after 40 hours use. Follow the instructions for cleaning filters in this booklet. Once the grease filters have been cleaned, reset
the reminder by pressing Motor OFF button for about 3 seconds until you hear the signal (beep).
Should the Suction power 3 LED starts to flash then push ON and power selection button and the Intensive Suction power
button simultaneously for more than 3 seconds to stop flashes.
Operating
Instructions
The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood.
Use the low speeds for normal use and the big her speeds for strong odors or fumes
Minimize cross drafts which will reduce the effectiveness of the hood.
8
Publicidad
