Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Tools required for installation
Screwdriver
(flat head, poziddve n°2 and torx 10)
Allen key 4ram
Electric ddll with twist bit _ 10 mm
CEILING/
,,,,,,,,,Y///////////////
Upper
Fastener
mln,
29 15116!!
Io
o I
i
I
t;elling
Bracket
Hooks
Preparation
of mounting
surface (Drywall)
1. Select a mounting height comfortable for the user and mark on wall behind
cooktop
2. Mark center line of cooktop and draw vertical line from bottom of hood to the
ceiling
3. Tape template, matching center-line and hood bottom as shown in Fig. 2
Distance from bottom of template to the ceiling must be minimum 2915/16"
4. Mark centers of the 6 fastener Iocatiensthreugh template on wall then remove
template.
5. Mark wall with hodzontal line 1" above highest and 1" below lowest fastener
location
6.
Find studs behind drywall by tapping wall or using a stud finder
Mark the center of the studs with a vertical line to the right and left of the
marked fastener location
Note: Each 2 x 6 must span at least 2 studs side to side
7. Cutout drywall along marked lines.
install each 2 x 6 between studs firmly flush with stud front. Make sure all
mounting screws will anchor to added lumber Replace drywall and refinish.
8. Remark center line and hood bottom on same location as before and tape
template on wall as in step 3 above
9. Mount 2 mounting hooks withwood screws (supplied in mounting hardware kit)
on locations marked on template, then remove template
10. Install duct cover ceiling bracket to wall flush to ceiling with drywall anchors
supplied
L
o
w
e
r
Fastener
Locations
Figure 2
5
Publicidad
