Black and Decker NST1118 Manual De Instrucciones página 8

• Push thehandle
completely onto thehousing
andposition itslightly u ntil i t
"snaps" into place (figure 8).
•Toadjust thehandle u por
down, press inonthebutton
(g)andraise orlower the
handle.
•The handle s hould be
adjusted sothatyour f ront
arm isstraight when the
trimmer isintheworking
position.
HEIGHT
ADJUSTMENT
• The overall height of the
trimmer can be adjusted by
loosening the collar (h) and
rotating it in the direction of
the arrow shown in figure 9.
• Move the upper housing
straight up or down. When
the desired height is
achieved, tighten the collar
by rotating it opposite of the
direction shown in figure 9.
O
zL WARNING:
Always use proper eye protection that conforms
to ANSI Z87.1 (CAN/CSA Z94.3) while operating this power tool.
zLCAUTION:
Inspect area to be trimmed and remove any wire,
cord, or string-like objects which could become entangled in the
rotating line or spool. Be particularly careful to avoid any wire which
might be bent outwardly into the path of the tool, such as barbs at the
base of a chain link fence.
SWiTCHiNG ON AND OFF
• To switch the tool on, squeeze the trigger lever.
• To switch the tool off, release the trigger lever.
• With the unit on, angle unit and slowly swing the trimmer side to
side as shown in figure 10.