Publicidad
Fixing the Irradiation Angle
Point the flash head at a wall or ceiling for bounce flash
photography. The area illuminated at ranges of 0.5 m
(1.6 feet) to 1.0 m (3.3 feet) will not be correct; point the
flash down.
Pressing the bounce unlock button, turn the
light-emitting section up/down and left/right.
Using the Wide Panel
Use the built-in wide panel for flash photography when the
focal length of the lens is wider than 12 mm.
Slide out the wide panel and place it on the flash
head.
≥ The estimated range display changes when the wide panel
is used.
≥ The lighting angle can be set to 14 mm, 12 mm, 10 mm and
7 mm only.
≥ Do not tilt the wide panel up.
≥ The ZOOM display will blink if the lens has a focal length of 16 mm or more.
Using the Catch Light Plate
Reflecting the flash light allows you to shoot with the catch
light effect, which reflects light in the models eyes.
Slide out the catch light plate.
Point the flash directly upward with the plate toward the
subject.
14
VQT5F44
90º
180º
7º
180º
Publicidad
