Publicidad
Idiomas disponibles
Idiomas disponibles
BmeAm +
MODELS
EW5630SS
,, EW5636SS
Page
5
A
6" ROUND
|
/
STEEL DUCT
F---
I
DUCT LENGTH
DECORATIVE
FLUE
_
10. Measure and install steel ductwork to hood duct connector
and ductwork rough-in on ceiling or wall. Use duct tape to
make all joints secure and air tight.
11. Plug power cord into wall outlet.
12. Slide the upper
decorative
flue section
into the lower
decorative flue section. NOTE For ducted applications,
the
louvers on the upper flue should be hidden by positioning
the louvers down, inside of the lower flue.
13. Carefully
place the upper/lower
flue assembly
into the
recessed area of the hood.
14. Slide the upper flue upward until it is aligned with its mounting
bracket. The bracket should be inside the flue. Secure the
upper flue to the upper flue mounting bracket using (2) 4ram
x 12mm mounting screws.
NOTE
9-10 ft. ceilings may require Flue Extension Model FXNE56SS
depending
on installation
height
(purchase
separately).
Discard the upper and lower flues supplied with your hood
and replace them with Flue Extension Model FXNE56SS.
INSTALL THE HOOD
(Non-Ducted
Hoods Only)
NON=DUCT
KIT MODEL
RKE56
CONTENTS
NON-DUCT PLENUM
ASSEMBLY
2 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
PanHead)
4 MOUNTING
SCREWS
(.188"x.375" _::::_
Cross
Recessed
_:}
Flat
Head)
_._
i
NON-DUCT FILTER
FLEXIBLE DUCT
4 FILTER MOUNTING CLIPS
NOTE
Non-ducted installations require Non-Duct Kit, Model RKE56
(purchase separately).
Flush with
_
I
the ceiling
I
t_
I
Center of
installation
1. Center the non-duct plenum over the hood location and flush
with the ceiling. Secure the non-duct plenum to the wall using
(2) 4mm x 38mm mounting screws.
2. Tighten the screws completely. Make sure that the non-duct
plenum is tight against the wall.
3. Remove damper flaps from damper / duct connector
and
discard flaps.
Publicidad
