Mounting Instructions - HQ-Power VDPLDJBAR6 Manual Del Usuario

warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device is designed for professional use on stage, in discos, theatres, etc. The VDPLDJBAR6
should only be used indoors with an alternating current of 230 VAC/50 Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong
their lives.
• Keep this manual for future reference.
4. Features
• ultra-light weight: special for DJ and mobile use
• movable spots, per spot there are 4 tri-colour LEDs for a smooth colour mixing
• pre-programmed modes, with presets for colours and RGB programs
• auto mode speed adjustable, and built-in microphone for sound activation
• easy control via included foot pedal, with black out function
5. Overview
Refer to the illustrations on pages 2 and 3 of this manual.
A connector for LED spot (4x)
B earth terminal
C power socket + fuse
D tripod securing knob
E DMX input
F DMX output
G microphone
H microphone sensitivity control knob
I connector for footswitch
6.

Mounting instructions

Choosing a Mounting Location
The VDPLDJBAR6 batten has been designed for indoor environments at temperatures up to
40°C. For proper operation, the unit must be operated with an unobstructed air convection
to its metal housing.
Do not:
• Operate the batten in environments with an ambient temperature higher than 40°C and a
relative humidity higher than 75%.
• Operate the batten in a closed environment smaller than 10 m³ unless forced air convection is
provided.
Secure Mounting
Risk of injury. Overhead mounting requires extensive experience: calculating workload
limits, determining the installation material to be used... Have the material and the device
itself checked regularly. Do not attempt to install the device yourself if you lack these
qualifications as improper installation may result in injuries.
• The VDPLDJBAR6 batten is designed to be mounted either on a tripod (not incl.) or on a truss
(not incl.) using 2 truss clamps (not incl.).
Tripod:
o Carefully follow the instructions that came with your tripod.
o Make sure that the diameter of the inserted tripod tube is not less than 25 mm as otherwise
secure mounting cannot be guaranteed.
o Slide the VDPLDJBAR6 over the tripod and secure it tightly by turning the knob [D]
clockwise.
Truss mounting:
o Have the batten installed by a qualified person, respecting EN 60598-2-17 and all other
applicable norms.
o The carrying construction must be able to support 10 times the weight of the batten for 1 hour
without deforming.
16/09/2011
VDPLDJBAR6
J DIP switch
K mounting points
L horizontal fixing knob
M vertical fixing knob (2 per spot)
N LEDs (4 per spot)
O program selection pedal
P sound control pedal
Q freeze pedal
R blackout pedal
5
©Velleman nv