Descargar Imprimir esta página

Domo DO91125 Manual De Instrucciones página 54

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Check that the temperature controller is not in the 0 position.
·
Plug in unit.
·
Use proper voltage.
Cools too frequently
·
The temperature setting is too cool.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Internal temperature not cold enough
·
Check connection of power cord to power source.
·
Plug in unit.
·
Check setting and adjust as needed.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Allow room for air to circulate around unit.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Unusual sounds
·
The appliance is not level. Readjust the adjusting feet and level the unit.
·
The unit is touching a wall or another object. Gently move the appliance.
There is water on the floor.
·
The condensation duct is blocked. See the chapter on cleaning.
·
Too much condensation has formed in the fridge, causing the reservoir to overflow. Too much
condensation is caused by a heat difference. Is the door closed properly? Have you put hot food in the
fridge? Does the seal still close properly?
The door does not close properly.
·
The door seal is deformed. Heat it gently using a hairdryer. The rubber seal will become flexible and
the magnetic strip in the rubber will automatically pull towards the appliance. After cooling, the
rubber stays in that position.
54
DO91125

Publicidad

loading