CASO DESIGN Classico WK 2200 Manual Del Usuario página 32

 Fill the pot with water and a commercial descaler. Perform a boiling process as
described in Chapter 15.1. After the descaling process, rinse the jug with fresh water
and perform a boiling process with fresh water.
► Regularly decalcifying your Classico WK 2200 will reduce the electricity used and
prolong the life of the device.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
Problem
The device turns off before
the water boils or reaches
the desired temperature.
The device does not switch
off.
The device cannot be
switched on.
18 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
were handled incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-recyclable waste under
any circumstances.
Please note
Attention
Cause
The jug is too heavily
calcified.
The lid is not closed
properly.
The device has not yet
cooled down properly.
The overheating protection
has been activated, for
example because there is
too little water in the jug.
Solution
Perform decalcification.
Close the lid properly.
Remove the jug from the
base and allow to cool for
at least 20 minutes. After
that, water can be filled
again and the device can
be used.
32