Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING
BATTERY
Although
your mower battery
was fully
charged
when it left the factory, it is nec-
essary to recharge
it before
initial use.
This will ensure that the battery operates
at full performance
capability.
There are two charge Indicator
lights on
your mower. The red light (1) glows while
the battery
is charging.
The green light (2)
glows when the battery
is fully charged.
During the mowing
season,
plug the
charger
into mower whenever
mower is
not being used.
Safety
Key
To prevent
accidental
start-up
or unautho-
rized use, your mower has a removable
Safety
Key (3). The mower will not oper-
ate when the Safety Key is removed.
The
Safety
Key has a hole in its center to allow
for storage
on a nail, out of the reach of
children.
CAUTION:
Always remove
Safety Key
from mower when
leaving
mower unat-
tended, even for a short period of time.
To Charge Battery
• Remove safety key (3).
• Plug the charger cord (4) into the recep-
tacle (5) on the mower. The charger
cord plug has a retaining clip (6) which
wilt lock the plug into the mower while
charging to avoid accidental
removal.
• Insert the 120 volt plug (7) of the charg-
er (8) into the wall receptacle.
• The red light on the mower should come
on Indicating
you have power and the
battery Is being charged. The red light
should extinguish
and the green light
Gome on when oharglng
is complete. It
takes approximately 24 hours to cherge
s fully dls0harged
battery,
For opllmun_ pert_]tm_mce during the
mowing
season,
always connect
the
mower to the charger
when mower is
not in use.
• To remove the plug from the mower,
press retaining
clip (6) firmly in the
direction
of the arrow and pull plug from
charging
receptacle
on mower.
TO ADJUST
CUTTING
HEIGHT
(1-1/2"
TO 3-1/2")
CAUTION:
Before
making any adjust-
ments, release
switch to turn mower off,
wait for blade to stop, and remove safety
key.
• Your mower features
a "one touch"
wheel height adjustment
system. This
system
adjusts
all four wheels
at the
same time.
• To raise or lower the cutting
height, place
the palm of your hand on the palm rest
(1) and with your fingers squeeze
upward.on
the finger grip (2) and hold.
(See Fig. A)
• While holding the finger gdp up, you _an
raise or lower the cutting height. The
mower has seven cutting height
posi-
tions. They are indicated by the scale
(1) and pointer (2) at the front of the
mower. (See Fig. B)
• When you have the mower at the height
Publicidad
