cecotec Cumbia POWER EXPRESSO 20 BARISTA CREAM Manual De Instrucciones página 24

ENGLISH
Step three
- Place the water tank back and the containers in place and turn the knob to the hot water
position. The indicator light will turn on.
It will start pumping water and hot water will flow out of the coffee spout and the steamer
-
tube. The descaling process will finish when there is no water released and you hear a
beep. The hot water light indicator will turn off and the indicator with a dot will flash,
showing this step has been completed. Turn the knob to this position. The device will enter
the standby mode.
Restoring default settings
Hold down the four buttons (On/Off, grind, single and double) at once. The device will beep and
the four indicators will flash at once. This will return the device to the default settings.
4. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning
-
it.
- Use a soft, damp cloth to clean the device surface.
- Never immerse the appliance in water or other liquid.
Do not use sponges, powder products or abrasive cleaning agents to clean the product.
-
Use a damp-proof sponge to remove dirt.
- After every use, clean the detachable parts with water and dry them thoroughly.
- If you are not going to use the machine for a while, clean the internal pipes by activating
the hot water function, as well as the single or double coffee function while the portafilter
is empty.
Warning
Accessories cannot be washed in the dishwasher.
- Use the accessory provided to clean the steamer tube after every use, removing possible
remains.
46
5. TROUBLESHOOTING
Problem Cause
Nothing appears on the Check if the product is
display. plugged in.
The indicator light on the The coffee tank (grinder) is
front part of the device is red. not correctly placed.
There are water splashes at The water tank or drip tray
the bottom of the device. are not correctly installed or
are full.
The device emits a ticking This is perfectly normal.
sound when switched on This sound is produced by a
and a hissing sound when properly functioning control
brewing coffee. valve.
The portafilter does not brew There is too much coffee or it
coffee or does it drop by drop. is too fine.
Coffee comes out without The coffee beans are wet or
foam and too watery. too coarse.
There is not steam released The steam nozzle is blocked
by the device. or the device has not
preheated.
When the device releases After releasing steam, the
steam, it does not allow to device needs to release
prepare coffee and starts pressure and lower the
pumping water automatically. temperature. While this
happens, you cannot perform
any other operation.
ENGLISH
Solution
Plug in the device and make
sure it is on.
Assemble it in place.
Make sure the water tank and
the drip tray are correctly
installed. If they are correctly
installed, the drip tray is
empty and the problem is not
solved, send your device to
be repaired by the Technical
Support Service of Cecotec.
Do not attempt to repair it by
yourself.
The amount of coffee cannot
exceed the limit. Change
the coffee bean setting to a
suitable value. Do not try to
press coffee that hard.
Use fresh coffee beans and
moderate the amount of
coffee.
The device will only emit
steam if it has been
preheated. The device
needs to be descaled. Clean
the steam nozzle with the
steamer cleaning accessory.
Releasing pressure and
reducing the temperature
takes up between 20 and 30
seconds. After it, the control
panel will return to the
standby mode and you can
prepare coffee again.
POWER EXPRESSO 20 BARISTA CREAM 47