Beper VE.113H Manual De Instrucciones página 13

Stand Fan Use instructions
PRODUCT AND ACCESSORIES Fig.1
1 – Front grid
2 – Closure nut
3 – Nut blades
4 – Blades
5 – Rear grid nut
6 – Rear grid
7 – Motor
8 – Swing button
9 – Body motor
ASSEMBLY INSTRUCTIONS Fig.2
1 – Put the base (19) on the floor.
2 – Insert completely the internal pipe (14) inside the external pipe (15).
3 – Insert the ornament base button (18) and fix the high adjustment handle (16).
4 – Fix the external pipe (15) to the base (19) with the 4 screws (included in packaging).
Important : strongly screw the screws to the base in order to guaranty the good stability of the fan,
otherwise the fan will dangerously swing.
5 – Take off the external pipe (14), and regulate it until the desired height. Strongly screw the high
adjustment handle (16).
6 – Place the control panels (12) on the pipe.
7 – Screw completely with the screw (14) in order that the control panels is well fixed to the intern
pipe (14).
8 – Place the rear grid (6) on the motor, in order that the holes of the grid are well inserted into the
motor of the fan
9 – Strongly and completely screw the rear grid (5) in order to block the grid on the motor.
10 – Insert the blades of the fan (4) on the motor (7) and completely screw the nut blade (3) on the
motor, in order to block the body motor.
11 – Assembly the 2 grid front (1) and rear ones (6) by inserting the closure nut (2), place the front
grid (1), on the rear grid (8). Close the nuts (2) to block the grids.
SPEED SELECTION
Choose the speed desired pressing on the buttons of the control panels (12).
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
When the fan is on, the night light switch on (11).
HEAD INCLINATION
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body, unscrew the regulation axis and change the inclination of the fan as desired
and screw the air strongly.
ATTENTION : DO NOT TRY TO FORCE THE INCLINATION POSITION IN ORDER TO AVOID
ANY FAILURE.
10 – Inclination set button
11 – Night light
12 – Control panels
13 – Screw for pipe
14 – Internal pipe
15 – External pipe
16 – High adjustment handle
17 – Screw pipe coupling
18 – Ornament base button
19 – Base
13
EN