Publicidad
Idiomas disponibles
Idiomas disponibles
30
What to do if...
The door will not open:
The machine vibrates or is noisy:
Spinning starts late or the machine does not
spin:
The machine makes an unusual noise:
No water is visible in the drum:
The display shows the alarm code
Problem
:
Possible cause/Solution
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait until the symbol 9.5 has gone off.
There is water in the drum.
• Select drain or spin programme to empty out
the water.
The transit bolts and packing have not been re-
moved.
• Check the correct installation of the appli-
ance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the
drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed
by reverse rotation of the drum. This may hap-
pen several times before the unbalance disap-
pears and normal spinning can resume. If, after
some minutes, the laundry is still not evenly
distributed in the drum, the machine will not
spin.
• The laundry load is perhaps to little, add
more items, redistribute the load manually
and then select the spinning programme.
The machine is fitted with a type of motor
which makes an unusual noise compared with
other traditional motors. This new motor en-
sures a softer start and more even distribution
of the laundry in the drum when spinning, as
well as increased stability of the machine.
Machines based on modern technology operate
very economically using very little water with-
out affecting performance.
Anti-flooding system has activated.
• Pull out the plug from the power socket,
close the water tap and contact the Service
Force Centre.
Publicidad
