Publicidad
Edge Kleen
TM
model shown (some models only)
Modele Edge Kleen
TM
illustrb (eertains modeles seulement)
Se mnestra el medele Edge Kleen
TM
(sblo algnnes modeles)
Edge Kleen
TM
model shown
(some models only)
Modele Edge Kleen
TM
illustrb
(eertains medbles seelement)
Se mnestra el modelo
Edge Kleen
TM
(sblo algnnos
medelos)
Edge Kleen
TM
model shown
(some models only)
Modele Edge Kleen
TM
illustr_ (certains
mod_les seelement)
Se muestra e mode e
Edge Kleen
TM
(sSIo algnnos
modelos)
Edge Kleen
TM
model shown
(some models only)
Modele Edge Kleen
TM
illustr_
(eertains
Se muestra el modeie
Edge Kleen
TM
(s51oalgnnos medelos)
PERiODiCMAINTENANCE (continued)
How To Replace Brushroll Belt
Step 1: Lowerhandleto floor to changebelt (FIG.21).
Step 2: Removethe two screws from the top of the hood(FIG.22).
Step 3: Lift hoodto remove(FIG.23).
Step 4: Lift right end of brushroll(FIG.24).
Step 5: Removeand discard belt.
Step 6: Placenew belt aroundmotor shaft.
Step 7: Placenew belt aroundbrushrollpulley.
Step 8: Align left end cap with base.Pushend cap securelyinto place.
Make surethe squareon the brushrollcap is in place(FIG.25).
Step 9: Pull right side of brushrollto stretch belt. Secureright end cap
into base.
iMPORTANT
Step 10: Rotate brushrollby hand2 full rotationsto properly
positionbelt.
Step 11: Placehood back on cleaner.Replaceand tighten two screws.
Step 12: Returnvacuumto upright position.
14
(CONTINUED)
Publicidad
