PRODUCT DESCRIPTION
All PestWest flytraps are made using the highest quality materials. The Chameleon Qualis IP is manufactured from 304 brushed
stainless-steel finish. The Chameleon Qualis IP is fitted with next generation Quantum X LED filament lamps with a peak
wavelength of 370nm coated with FEP shatter-resistant coating as standard as well as utilising the PestWest Plastic LED sticky
board.
The new Quantum X LED filament lamp is made with the familiar T5 form factor (glass tube, end caps and pins) used in our
conventional 14W T5 fluorescent Quantum lamps.
The main advantages of the Quantum X LED filament lamp technology are the extended pattern of light distribution and the
improved energy efficiency. Increased fly attraction is partly due to the LED filaments light distribution, which is around 360°
compared with only 120° typical of high power SMD (Surface Mounted Device) LEDs found in older first-generation LED insect
light traps. LED filaments are also more energy efficient than both high power SMD UV-A LEDs and also conventional fluorescent
lamps.
The Quantum X LED filament lamp consists of 18 individual LED filaments mounted on a frame and hermetically sealed within a
glass tube with a state-of -the art gas cooling system, which is far superior to traditional metal heat sinks.
Each LED filament has 24 individual LEDs which are mounted on a translucent substrate, which enables the Quantum X LED lamp
to provide light in all directions. The combination of 360° light distribution and the softer intensity of light produced by far more
LEDs (432 per lamp) gives the Quantum X superior fly catching performance.
The Chameleon Qualis IP is IP66 rated to BS EN 60529-1992 standard for water and dust ingress protection.
TECHNICAL SPECIFICATION
Voltage Range
Frequency Range
Power Consumption
Ingress Protection Rating
Classification
Ambient operating temperatures
LED Driver type
Area of Coverage
Sticky board
LED Lamp type (2 QTY)
Mounting Method
Unit Dimensions mm
Weight 5.6Kg
UNPACKING YOUR UNIT
Each unit is carefully inspected and packed before leaving our factory. Before discarding the outer carton, examine for obvious
evidence of transport damage. Remove the unit and pay attention to the removal of all packing materials, before installing the
unit.
MODE OF OPERATION
Electrical flytraps operate on the principle that most flying insects are attracted to light, particularly to the ultraviolet (UV) end of
the light spectrum. Since insects are still active and will fly at night, traps should be left operating 24 hours a day.
SITING
The efficiency of the unit can be affected by the intensity of other light sources, e.g.: daylight.
Therefore, mount the unit where competition from other light sources is minimised.
In food areas, mount close to, but not directly over, exposed food or preparation surfaces (preferably to attract flies away from
sensitive areas, rather than attract towards them). Observe where the flies tend to congregate and if possible, put your flytrap in or
close to that area. Site the units near where flies are likely to gain access, e.g.: doors and windows opening to the outside, especially
dustbin areas. Position the trap where it can be easily reached; not over working machinery where access may be difficult or
dangerous.
220-240V
50-60Hz
13.5W
IP66
Class 1
0 to +40°C
Constant Current
90-120m²
135-000239 (6 PK)
130-000321 Quantum X LED 370nm 550mm T5 Shatter-Resistant
Wall Mounted
H320 x W636 x D55
5.6 kg (unboxed)
ENGLISH
3
1