Approved Multiengines; Mounting The Multitool - Stihl FC-MM Manual De Instrucciones

English
1
Use the gunning sight (1) to line up
N
the blade on the edge.
Cleaning the blade
Pieces of grass or roots may become
tightly wrapped around blade mounting
during operation. Clean the blade as
follows:
Shut off the engine.
–
Wear work gloves.
–
Pull the hitch pins out of the axle.
–
Pull the blade off the axle.
–
Remove pieces of roots, plants and
–
soil.
Refer to "Mounting the MultiTool" for
mounting instructions.
10

Approved MultiEngines

Only use MultiEngines supplied by
STIHL or expressly approved by STIHL
for use with the MultiTool.
This MultiTool may only be used in
combination with the STIHL MM 56
MultiEngine.

Mounting the MultiTool

Removing Existing MultiTools
WARNING
Wear gloves to reduce the risk of injury
from contact with sharp MultiTools
and/or hot surface of gearbox.
Remove the hitch pins and pull the
N
MultiTools (if fitted) off the axle –
see also "Mounting the MultiTool" in
the instruction manual of the other
MultiTool.
Clean the gearbox if necessary.
N
Checking Position of Gearbox
WARNING
To reduce risk of injury from the
MultiTool rotating in the wrong direction,
check that position of gearbox is correct
and adjust if necessary.
FC-MM