Storing The Machine; Maintenance And Care - Stihl FC-MM Manual De Instrucciones

English
Check that the MultiTool is not
N
touching the ground or any other
obstacles. The unit must rest on the
engine flange and the support on
the frame.
Make sure you have good balance
N
and secure footing – as shown in the
illustration.
WARNING
To reduce the risk of injury from contact
with the rotating attachment, always
stand to the side of the power tool, never
in front of the attachment.
With your left hand on the loop
N
handle, press the unit firmly against
the ground – do not touch the
throttle trigger or lockout lever.
NOTICE
Do not stand or kneel on the handlebar
or frame.
WARNING
The attachment may begin to move as
soon as the engine starts. For this
reason, blip the throttle after starting –
the engine returns to idling speed.
Now follow the starting procedure
described in the MultiEngine instruction
manual.
Stopping the Engine
See MultiEngine instruction manual.
N
12

Storing the Machine

For periods of 3 months or longer
Remove, clean and inspect the
N
cutting blade.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.

Maintenance and Care

The following intervals apply to normal
operating conditions only. If your daily
working time is longer or operating
conditions are difficult (very dusty work
area, etc.), shorten the specified
intervals accordingly.
All accessible screws and nuts
Retighten if necessary
N
Wheel
Visual inspection before starting
N
work
Replace if necessary
N
Blade
Visual inspection, check tightness
N
before starting work and after every
refueling stop
Have checked for out-of-balance if
N
necessary, replace if out-of-balance
Replace if damaged
N
Safety labels
Replace illegible safety labels
N
FC-MM