MTD 450 Serie Manual Del Operador página 7

Assembly & Set-Up
3
Contents of Carton
One Chipper Shredder
One Hopper Assembly
One Chute Deflector
One Operator's Manual
One Bag
One Safety Glasses
One Engine Operator's Manual
One Chipper Chute
One Bottle of Oil
Assembly
NOTE:This unit is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual BEFORE operating your chipper shredder.
Hopper Assembly
1. Remove six hex nuts and washers from the weld studs on
the impeller housing. Do not remove the support plate. See
Fig. 3-1A.
Figure 3=1
2. Place hopper assembly into position in front of impeller
housing, aligning holes in hopper assembly collar with
weld studs. See Fig. 3-1B.
3. Slide hopper assembly onto weld studs and replace
washers and hex nuts. See Fig. 3-1C. Do not tighten
completely.
4. Lift hopper assembly up to impeller bracket assembly. See
Fig. 3-2A.
5. Slide the release rod out slightly to hook the hopper
bracket onto the rod. See Fig. 3-2B.
6. Tighten the six hex nuts that secure hopper assembly to
impeller housing and also tighten the hex nuts that secure
hopper bracket to hopper assembly.
f
/
/
Figure 3-2
Chute Deflector
1. Remove the wing knobs from each side of the lower
impeller housing. See Fig. 3-3A.
f
Figure 3=3