Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: This equipment complies with
IEC 60601-1-2:2007 for electromagnetic compatibility
for medical electrical equipment and/or systems.
However, because of the proliferation of radio-
frequency transmitting equipment and other sources of
electrical noise in healthcare and other environments,
it is possible that high levels of such interference due
to close proximity or strength of a source might disrupt
the performance of this device.
CAUTION: Portable and mobile RF communications
equipment can affect medical electrical equipment.
CAUTION: This equipment is not intended for use
during patient transport outside the healthcare facility.
CAUTION: This equipment should not be used adjacent
to or stacked with other equipment.
CAUTION: These materials that contact with the
patient's skin contain medical silicone and ABS plastic
enclosure all pass the ISO10993-5 Tests for invitro
cytotoxicity and ISO10993-10 Tests for irritation and
delayed-type hypersensitivity.
AFTER SALES SUPPORT
800-347-5678
SETUP / ASSEMBLY
BATTERY INSTALLATION
1
Install two AAA batteries into the battery compartment.
Match the plus (+) and minus (-) signs in the compartment.
s NOTICE: If the polarities are not matched, damage may
be caused to the oximeter.
2
Slide the battery door cover horizontally along the arrow as
shown above.
WARNING: Do not mix old and new batteries; this could
result in fire or explosion.
WARNING: Do not mix alkaline, standard (carbon-zinc),
or rechargeable (ni-cad, nimh, etc) batteries; this could
result in fire or explosion.
s NOTICE: Remove the batteries if the pulse oximeter will
not be used for an extended period of time.
5
cs@grahamfield.com
Publicidad
