Publicidad
Idiomas disponibles
Idiomas disponibles
Set Recurring Schedule
Follow the procedure below to set a recurring schedule. Once set, the lights will turn on daily at the
same time each day and stay on for the duration that was selected. If the lights are already on, they
will change to the scheduled color or show.
The following example shows that the lights will turn on automatically every day (beginning immediately
after the schedule is saved) and shut off after 2 hours.
1
2
3
4
Rotate CENTER
Push the
Wait until all
Briefly push the
KNOB to select
SCHEDULE
LEDs stop
CENTER KNOB to
desired color or
button
blinking
save
show
5
6
Select the number
Push and hold the
of hours (each lit
ENTER/BRIGHTNESS
LED = 1 hour)
button for 3 seconds
to save
The Light Controller will indicate that a new schedule has been set by blinking LED 4 (see LED Indicator
Codes on page 10) and then revert to Show/Color mode.
Cancelling a Countdown Timer or Schedule
The procedure for cancelling a countdown timer or a schedule is identical.
Push and hold both the SCHEDULE button and the ENTER/BRIGHTNESS
button for 3 seconds. The Light Controller will cancel the existing settings
and will revert to Show/Color mode.
The Light Controller will indicate that a countdown timer or schedule has
been cancelled by blinking LED 6 (see LED Indicator Codes on page 10).
Push and hold the
SCHEDULE and ENTER/
BRIGHTNESS buttons for 3
seconds
8
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Publicidad
