Publicidad
Idiomas disponibles
Idiomas disponibles
TEMPERATURE ADJUSTMENT AND FUNCTION ACTIVATIONS (Fig. 7)
To turn on the appliance, press the ON / OFF button ON/OFF " ", for at least one second.
When first switched on, the product is positioned at a temperature of 70°C. Set the desired temperature by
choosing a level between 40 ° C and 80 ° C, by pressing the "SET" button. After 3 seconds without any
action, the set point will be confirmed and stored. During the heating phase, the LEDs (40°C -> 80°C)
relating to the temperature reached by the water are steady on; the following ones, up to the set temper-
ature, flash progressively. If the temperature drops, for example as a result of a water withdrawal, the
heating is reactivated automatically and the LEDs between the last steady lit and the one relating to
the set temperature start flashing progressively again. In the event of a power failure, or if the product
is turned off using the ON/OFF " " button. The last set temperature is stored.
During the heating phase, a slight noise may occur due to the heating of the water.
ANTI-FREEZE FUNCTION
The anti-freeze function is the appliances automatic protection to avoid damages caused by very low tempe
ratures below 5 °C, in the event in which the product is turned off during winter. It is recommended that the
product remains plugged in to the mains power, even if iiis inactive for a long time.
Attention: the function is enabled, but it is not indicated in case of activation. Once the temperature rises to a
safer level such as to avoid damage from ice and frost, the water heating is switched off again.
ECO FUNCTION
The ECO function is activated by pressing the "SET" button until the ECO LED is on.
The ECO function aims to produce hot water by learning the user's habits. So, for the first week the
product stores the withdrawals and the timings in which these take place. From the following week water
heating is performed with respect to what the water heater has previously learnt.
If the user wants to restore the function and start a new learning period it is necessary to press the "SET"
button for 10 seconds (the ECO LED will flash).
If the ECO function is active and the "SET", button is pressed, the function will be disabled and the cor-
responding selected temperature will be visualized (40°C -> 80°C).
BOOST FUNCTION
The BOOST function is activated/deactivated by pressing the "BOOST" button (basic model not Wi-Fi),
or through an APP (Wi-Fi model). If the function is active, the corresponding LED will be lit (only in the
basic non-Wi-Fi model). The Boost function temporarily sets the setpoint temperature at 80° bypassing
the previous operating mode and self-deactivates once the setpoint is reached. In this way, the maxi-
mum amount of hot water will be available. The Boost function is automatically deactivated in the event
of: blocking error; if the appliance is in "OFF"; or if the "SET" button is pressed to change the setpoint.
WI-FI FUNCTION
For further information about Wi-Fi configuration and the product registration procedure, refer to the
enclosed quick start guide dedicated to connectivity, or visit the website:
https://discover.ariston-net.remotethermo.com
Connection status description
Slow flashing
Wi-Fi
Rapid flashing
Button
Double flashing
ON
OFF
Wi-Fi RESET: to carry out a reset, press the"
18 / EN
USER INSTRUCTIONS
The Wi-Fi module is ON
The Wi-Fi module is in Access Point mode
The WI-Fi module is connecting to the home network
The Wi-Fi is ON and connected to the home network
The Wi-Fi module is OFF
" and "
" buttons simultaneously for 10 seconds
Publicidad
