Descargar Imprimir esta página

Sony XAV-AX8500 Manual De Instrucciones página 15

Ocultar thumbs Ver también para XAV-AX8500:

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Decide the installation location on the
dashboard, then clean the attachment
surface.
Choose a flat surface where:
 the GPS antenna (aerial)  can be positioned
horizontally.
 operation of the passenger-side airbag is not
impeded.
 GPS satellite reception is not blocked by
anything inside the car or the windshield
(windscreen) wipers.
2
Remove the tape of the metal plate , then
attach it on the dashboard.
3
Remove the tape of the GPS antenna (aerial)
, then attach it on the metal plate .
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• Be sure to use the metal plate , otherwise signal
reception may be poor.
• Do not install the GPS antenna (aerial)  close to other
electrical equipment, otherwise signal reception may be
unstable.
• If the surface of the metal plate  is cold, the tape may
not stick firmly. Warm up its surface with a hair dryer, etc.,
before applying the tape.
• If there is no flat surface on which to install the GPS
antenna (aerial) , bend the metal plate  to fit a curved
surface before installing.
Using the steering wheel remote
control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1  is
required before use.
1
Select [Settings]  [System]  [Steering
Wheel Settings].
2
Set the [Custom] switch to [On].
You can make the registration to enable the
steering wheel remote control.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable
RC-SR1 
• Refer to the support site for details, then connect
each lead properly to the appropriate leads.
Making an improper connection may damage the
unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced
technician for help is recommended.
• When connecting the iDataLink Maestro module
(not supplied), do not connect any device to the
REMOTE IN terminal (blue). Likewise, when
connecting a device to the REMOTE IN terminal
(blue), do not connect the iDataLink Maestro
module (not supplied) to the IDATA LINK I/F
terminal (black).
When using an adaptor for the steering wheel
remote control
Depending on the type of car, use an adaptor for
the steering wheel remote control (not supplied).
1
Select [Settings]  [System]  [Steering
Wheel Settings].
2
Set the [Custom] switch to [Off].
The adaptor for the steering wheel remote
control is enabled.
REMOTE IN
Black
Green
Brown
GND
Input 1
Input 2
15
EN

Publicidad

loading